Error in job Job-2: THE PROBLEM IS TOO LARGE TO RUN WITH Abaqus.

Large warping that develops during an analysis often corresponds to severe distortion of the underlying elements.

the problem is too large to run with abaqus. typically this caused by the existence of a very large element such as a substructure with a large number of retained dof. a large cavity in a cavity radiation

Please report any * * errors encountered in either the documentation or results * * immediately to LST through your site focus.

如标题，没有错误和警告的信息实在不知道该从哪里开始检查。后来发现电脑容量刚好不够了，这是否可能是因为电脑容量不足导致的？

Solver problem. Numerical singularity when processing node TERMINAL-1.136 D.O.F. 1 ratio = 100.E+09 .Material/behavior grip has been redefined in the current analysis.

请问大家在进行abaqus仿真时，有没有可能因为电脑睡眠或者断网而造成这种错误？

小弟做一个颗粒压缩场景，材料就用弹塑性模型，颗粒模型核模具如图，其中模具部分设置为了刚体，120s的显式分析，加载为100MPa，现在有两个问题，首先是计算过慢，如监控器中所示，整体网格也就五万多，CPU是9950x，14核计算，刚开始两分钟出0.06s，后面掉到0.004s了，模型也不大，质量缩放给的5，该怎么优化呢？此外就是算到2s多就出现标题的提示报错，上网查了说了网络问题，但网络一直连着，

. ************************************************************************ OptiStruct error termination report printed to file "h22.stat".

This may cause convergence problems.

螺栓连接钢管混凝土，三个分析部，一二是螺栓荷载施加，能够计算，第三步在柱顶与截面耦合的点施加一个竖向位移，计算了几步就不收敛了，显示“ The analysis has been terminated due to previous errors.

*** ERROR 14: Missing property # 2 referenced by CQUAD4 # 13393. **************** Too many error messages. Aborting run. Current limit is 10000.

If there are no error messages and you cannot resolve the problem,please run the command "abaqus job=support information=support" to report andsave your system information.

If there are no error messages and you cannot resolve the problem, please run the command "abaqus job=support information=support" to report and save your system information.